Reserve your Spring 2021 Nuc NOW!!!

Lyson Formic or Acetic Acid Dispenser

C$3.85

Formic acid 

Formic acid has been known for years and proven in apiaries. It is an organic chemical compound. The biggest advantage of its application is that it fights Varroa Mites not only on bees themselves but also those hidden inside the cells. The 85% formic acid treatment, if carried out correctly, is safe for bees and is highly effective in reducing varroa mites.

Acetic acid

The challenge that beekeepers face every year is to keep the frames safe in storage from Wax Moth. One way to protect the combs is to apply acetic acid to them. Its concentration in the air makes the pest activity to cease. Before these frames are put back in the hive, they need to be aired out, as the smell of the acetic acid on them discourages bees from using the combs.

How to use the dispenser?

The optimal time for the treatment is late summer, early autumn. It is safe to carry it out when the air temperature outside does not exceed 23-24 °C. The dispensers should be filled with formic acid few hours before putting them in the hives. This is to ensure that the absorbent material contained in them soaks up evenly. This can be done even a day before they are scheduled to be placed in the hives. Formic acid vapours are heavier than air, so the dispenser should be placed on top of the nest. Lyson hive ceilings are equipped with holes compatible with the dispensers, so they can be placed under the roofs without the slightest interference with the nest and without disturbing the bees. The evaporation surface of our dispensers can be adjusted. In the initial phase the opening should be small. The bees usually seem irritated at the beginning of the treatment; they come out in front of the hive and fly around it. Over time this behaviour disappears, and if the temperature does not exceed the maximum allowed value, the evaporation surface should be increased. The adjustment of the dispenser offers 6 opening sizes. This feature allows to take notes, and check the correlation between the temperature and the size of the opening and the behaviour of bees in colonies of different strength.  This subsequently allows the beekeeper to formulate an appropriate, effective and safe way for using the dispensers. 70-80 ml of acid can be poured into a single device at a time. This is the amount that the dispenser is able to absorb and evaporate efficiently. Some people assume that in order to effectively control Varroa, approximately 150 ml of formic acid should be used, which requires refilling the device. Currently, however, some scientists are inclined to conclude that a dose of 40 ml is enough to effectively get rid of Varroa mites. One maximum dose that the dispenser can hold should then be sufficient if the formic acid treatment is a part of a wider, all-season Varroa -fighting strategy.

How to use the dispenser to protect the unused frames against the Wax moth?

The frames taken out of the hives should be stored in unused hive bodies. Ventilation plugs must be replaced with full ones to prevent the acetic acid vapours escaping outside. Stack the hive bodies with frames in them up as high as possible, depending on the room they stand in. Keep the spacing between the frames a little looser than normally. In a 10-frame body, placing 9 frames improves the vapour circulation and thus the efficiency of the treatment. The dispenser should also be placed near the top. Cover the top body with a ceiling and place the dispenser in its dedicated opening. However In this case the evaporation area of the dispenser must be fully opened so that the concentration of acetic acid in the air around the frames quickly reaches a pest repelling level. Every few days, check if the absorbent material hasn’t dried out and add acid if necessary. When the air temperature drops to 10°C or below, application can be discontinued. Under these conditions, the moth activity stops and the frames are safe.

Reviews

Reserve your Spring 2020 Nuc NOW!!!